Enabling IPv6 traffic over a tunnel entails numerous steps, and the exact procedure varies based on the type of tunnel (e.g., IPv6-in-IPv4 tunnel, GRE tunnel, etc.) and the operating systems used. The following is a general tutorial for enabling IPv6 traffic over an IPv6-over-IPv4 tunnel (which is commonly used to enable IPv6 access over an IPv4 network). You must configure a tunnel endpoint on both the client and the server. This involves specifying the IPv4 address of the tunnel endpoint, the IPv6 addresses of the local and remote ends, as well as the tunnel's IPv4. You must configure a tunnel endpoint on both the client and the server. This involves specifying the IPv4 address of the tunnel endpoint, the IPv6 addresses of the local and remote ends, as well as the tunnel's IPv4. Example ConfigurationOn your router or firewall, configure IPv6 routing to ensure that IPv6 traffic is routed through the tunnel. This typically involves adding routes for IPv6 networks via the tunnel interface.
Code:
interface Tunnel0ipv6 address 2001:db8:1::1/64ipv4 address 192.0.2.1 255.255.255.252tunnel source 192.0.2.1tunnel destination 198.51.100.1Statistics: Posted by maxturns — Fri Jul 26, 2024 9:28 am